How do you get air pocket out of cooling system? Air pockets in the cooling system can cause a variety of problems, including reduced cooling efficiency, overheating, and even engine damage. Therefore, it is crucial to identify and remove air pockets promptly. In this article, we will discuss the common causes of air pockets in the cooling system and provide step-by-step instructions on how to effectively get rid of them.
The primary cause of air pockets in the cooling system is the air that gets trapped during the filling process. This can happen when the coolant is added to the system or when the system is refilled after a leak or repair. Additionally, air can enter the system through the radiator cap, thermostat, or any other component that allows fluid to flow.
Here are the steps to follow in order to get air out of the cooling system:
1.
Prepare the necessary tools and materials. You will need a funnel, a container to collect the old coolant, a rag, and a new coolant mixture that matches the specifications of your vehicle.
2.
Locate the radiator cap and remove it. Be cautious as the pressure inside the system may be high, and the coolant may spray out.
3.
Start the engine and let it idle for a few minutes. This will allow the coolant to circulate and warm up the engine.
4.
Open the coolant reservoir cap and look for bubbles or air pockets. If you see any, this indicates that air is trapped in the system.
5.
While the engine is still running, locate the highest point in the cooling system, which is usually the overflow tank or the highest point of the radiator. Open the corresponding coolant reservoir cap and let the air escape. Use a rag to catch any coolant that may spray out.
6.
After the air has been released, close the reservoir cap and fill the system with the new coolant mixture. Make sure to fill it to the proper level as indicated in the vehicle’s manual.
7.
Restart the engine and let it idle for a few minutes. This will allow the coolant to circulate and push out any remaining air pockets.
8.
Recheck the coolant level and top off if necessary. Make sure the system is fully sealed and there are no leaks.
9.
Repeat the process if you still see air pockets or if the coolant level drops quickly.
By following these steps, you should be able to effectively remove air pockets from your cooling system. However, if you are still experiencing issues, it may be necessary to consult a professional mechanic to diagnose and repair any underlying problems.
